Oldham iTrans - Page 84

Index iTrans Fixed Point Single/Dual Gas Monitor
F-4 iTrans User Manual (P/N: 77023554-1)
Normally Open (NO) contact ................................ 4-2
NRTL laboratory ................................................... 1-3
O
O
2
......................................................................... A-2
open loop condition ............................................... 5-2
operating range ...................................................... 1-2
ordering matrix ...................................................... B-1
output wiring, J1 .................................................... 4-3
outputs ................................................................... 1-2
over-range
alarm ................................................................... iii
condition ........................................................... 5-2
oxygen ....................................... iii, 1-2, 1-3, 2-2, 6-3,
7-1, A-2, B-2
P
parity bits ............................................................... 6-1
password ................................................................ 5-8
phosphine ....................................................... 1-3, B-2
PLC ........................................................................ 4-9
poured wire seal ..................................................... 4-2
power ......................... 1-1, 4-1, 4-2, 4-3, 4-4, 4-7, 4-9,
4-12, 5-1, 5-16, 6-4, 7-2
AC and DC in same conduit ............................. 4-1
supply ......................................................... 1-1, 4-4
wire recommendations ...................................... 4-1
wiring, J1 .......................................................... 4-3
pressure .................................................................. 7-1
range ................................................................. 1-2
program mode ........................................................ 5-2
Programmable Logic Controller (PLC) ................ A-2
programming
access code ........................................................ 5-8
mode .........................................5-3, 5-4, 5-7, 5-10,
5-11, 5-12, 5-13, 5-15
protection class ...................................................... 2-2
protocol .................................................................. 6-6
public 485 GND .................................................... 4-3
pumps ............................................................. 1-1, 9-1
push button operation ............................................ 5-8
Q
qualified personnel .......................................... iv, 9-2
R
real time clock ............................. 5-16, 5-17, 6-5, A-2
reed switch ................................ 2-3, 2-4, 5-2, 5-4, 8-2
location ...................................................... 2-3, 2-4
register 40102 ........................................................ 6-1
register 40202 ........................................................ 6-2
relay board ...................................................... 1-1, 4-2
relays ................................................. iii, 1-1, 1-2, B-1
contact capacity................................................. 1-2
driving loads ..................................................... 4-2
non-latching ...................................................... 4-2
user-programmable ........................................... 1-2
remote sensor .................................................. 4-5, 4-6
Remote Terminal Unit (RTU) ....................... 6-1, A-2
remote unit ............................................................. 2-4
replacing sensors.................................................... 7-2
resistors .................................................................. 4-4
resolution ............................................................. 5-16
span gas concentration ...................................... 5-8
restart .................................................................... A-2
routine maintenance ............................................... 7-1
RS485 .................................................................... 1-2
S
safety ........................................................................iv
sealing device ........................................................ 1-5
secondary higher-power relay ................................ 4-2
self test ................................................................... 5-1
sensor(s) ............................ 1-4, 4-2, 4-4, 4-5, 4-7, 5-1,
5-17, 7-1, 7-2, 9-1
ATEX-certified ................................................. 1-4
board ................................................. 4-10, 6-1, 7-2
calibration service to ........................................... iii
catalytic ............................................................. 7-1
error .................................................................. 8-2
handling ............................................................ 7-1
head ................................................................... 4-4
maximum distance ................................... 4-4, 5-17
openings .............................................................. iii
ranges ................................................................ 1-3
remote ............................................... 4-2, 4-4, 5-17
replacement ....................................................... 7-2
span ............................................................ 5-2, 5-8
specifications .................................................... 2-2
storing ............................................................... 7-1
type ..................................................... 2-2, 5-4, 5-5
wiring, J3 .......................................................... 4-4
serial bus
abnormal behavior ............................................ 6-1
setpoint ................................................ 5-9, 5-10, 5-11
setting compound ................................................... 1-5
setup menu ............................................................. 5-5
shielded cable .................................4-1, 4-4, 4-7, 5-17
shielding .................................................. 4-2, 4-4, 4-7
screw ................................................................. 4-2
signal outputs ......................................................... 1-2
signal wire ............................................................. 4-3
recommendations .............................................. 4-1
silicone compound vapors ....................................... iii
silicone vapors ......................................................... iii
siren ....................................................................... 4-2
slave address .......................................................... 4-9
slave units .............................................................. 6-1
SMART sensor ...................................................... 8-2
error .................................................................. 5-2
SO
2
........................................................................ A-2