Specifying Printer Driver Settings 2-13
[Manually Print on 2nd
side]
Select whether or not to print on the back
side of paper that has already been printed
on.
îš„ The default setting is [Off].
[Paper Sizes] Specifies the paper size. An irregular paper
size cannot be selected.
[Collate] If [On] is selected, all pages in the documents
are printed as sets of printouts.
îš„ The default setting is [Off.]
[Duplex Options] Specifies the duplex print binding position as
[Simplex], [Long Edge], or [Short Edge], if the
duplex unit for the printer has been installed.
îš„ The default setting is [Simplex].
[Select Color] Specifies the color for printing as [Color] or
[Grayscale].
îš„ The default setting is [Color].
[Color Separation] Specifies the color separation as [On] or [Off].
îš„ The default setting is [Off].
[Brightness] Specifies the brightness of the image as
[-15%], [-10%], [-5%], [0%], [5%], [10%], or
[15%].
îš„ The default setting is [0%].
[Edge Strength] Set the edge strength to [Off], [Low], [Middle]
or [High].
îš„ The default setting is [Middle].
[Toner Save] Select whether or not economy printing is
used.
îš„ The default setting is [Off].
[Auto Trapping] Select whether or not neighboring colors are
printed superimposed in order to prevent
white space around images.
îš„ The default setting is [Off].
Parameters Settings
To Next Page
Loading...
Need help?
General
