Specifying Printer Driver Settings2-12
Printer Driver Settings
Options Installed
General
Parameters Settings
[Paper Source Unit] Select [Unit 3 + Unit 4], [Unit 4] if an optional
lower feeder unit for the printer has been
installed.
The default setting is [Disabled].
[Hard Disk] Select [None], or [Installed] for the storage
unit that is installed.
The default setting is [Installed].
[Printer Memory] Select [512 MB], or [1536 MB] if an optional
memory for the printer has been installed.
The default setting is [512 MB].
Parameters Settings
[Nearest Size and Scale] If no paper tray contains paper of the speci-
fied size, the page is automatically enlarged
or reduced and paper of the most appropriate
size is selected.
The default setting is [Off].
[Resolution] Displays the image resolution (High Quality)
for printing.
[Paper Type] Specifies the paper type as [Printer Default],
[Plain Paper], [Recycled], [Glossy], [Glossy
2], [Label], [Thick 1 (91 - 150g/m2)], [Thick 2
(151 - 210g/m2)], [Letterhead], [Envelope],
[Postcard], [Single Side Only (60 - 90g/m2)],
or [Special Paper (60 - 90g/m2)].
The default setting is [Printer Default].
[Paper Source] Specifies the paper source as [Tray 1], [Tray
2], [Tray 3], [Tray 4], [Tray 1 (Manual Feed)],
or [Auto].
The default setting is [Auto].
To Next Page
Loading...
