2HA/2HB
1-2-6
1. Connect the power cord to the connector on the copier.
2. Insert the power plug into the wall outlet and turn the power switch on.
1. Enter the maintenance mode by entering "10871087" using the numeric keys.
2. Enter "130" using the numeric keys and press the start key.
3. Press the start key to execute the maintenance item.
Installation of toner starts and "10" is indicated in the copy quantity display. Each time one minute elapses, the
indicated value decrements. When the installation is complete, "Gd" will be displayed if the installation is suc-
cessful or "nG" will be displayed if it has failed.
4. Press the stop/clear key.
1. Load paper in the drawer.
1. Enter "000" using the numeric keys and press the start key.
2. Select "d-L" and press the start key to output a list of the current settings of the maintenance items.
3. Press the stop/clear key.
1. Enter "001" using the numeric keys and press the start key.
The machine exits the maintenance mode.
1. Place an original and make test copies.
1-2-3 Setting initial copy modes
Factory settings are as follows:
Maintenance
item No.
Contents Factory setting
U253 Switching between double and single counts Double count
U254 Turning auto start function on/off ON
U258 Switching copy operation at toner empty detection SINGLE MODE
U260 Changing the copy count timing After ejection
U277 Setting auto application change time 30
U342 Setting the ejection restriction ON
U343 Switching between duplex/simplex copy mode Simplex copy
U344 Setting preheat/energy saver mode ENERGY STAR
Connect the power cord.
Installing the toner (maintenance item U130).
Load paper.
Output an own-status report (maintenance item U000).
Exit maintenance mode.
Make test copies.
Completion of the machine installation.
To Next Page
Loading...
Need help?
General