2HA/2HB
1-3-2
(2) Maintenance mode item list
Section
Item
No.
Content of maintenance item
Initial
setting*
General U000 Outputting an own-status report -
U001 Exiting the maintenance mode -
U002 Setting the factory default data -
U004 Checking the machine number -
U005 Copying without paper -
U019 Displaying the ROM version -
Initialization U020 Initializing all data -
U021 Initializing memories -
Drive, paper
feed and
paper convey-
ing system
U030 Checking motor operation -
U031 Checking switches for paper conveying -
U032 Checking clutch operation -
U034 Adjusting the print start timing
Adjusting the leading edge registration
Adjusting the center line
Adjusting the trailing edge margin
0.9/1.2/1.3/1.3/1.3/1.0
-1.0/0.4/-1.2/-1.2/-1.2/0.3
0.0
U035 Setting folio size
Length
Width
330
210
U051 Adjusting the amount of slack in the paper 20/0/ 0/ -20/ -20/0
U053 Performing fine adjustment of the motor speed 0.3/0/-0.5/-0.1/-1.3/-1.5/0.5
0.1/0.3/0.3
Optical U060 Adjusting the scanner input properties 12
U061 Turning the exposure lamp on -
U063 Adjusting the shading position 0
U065 Adjusting the scanner magnification
Main scanning direction
Auxiliary scanning direction
0
-10
U066 Adjusting the scanner leading edge registration 7
U067 Adjusting the scanner center line -4
U068 Adjusting the scanning position for originals from the DP 0
U070 Adjusting the DP magnification 0/0
U071 Adjusting the DP scanning timing 0/0/0/0
U072 Adjusting the DP center line 0/0
U073 Checking scanner operation -
U074 Adjusting the DP input light luminosity 1
U076 Adjusting the DP automatically -
U087 Turning the DP scanning position adjust mode on/off ON/35
U088 Setting the input filter (moire reduction mode) Off
U089 Outputting a MIP-PG pattern -
U092 Adjusting the scanner automatically -
U093 Setting the exposure density gradient
Text/text and photo/photo mode 0/0/0
U099 Checking the original size detection -
*Initial setting for executing maintenance item U020
To Next Page
Loading...
Need help?
General