2HA/2HB
1-3-3
High voltage U100 Setting the main high voltage
Grid control voltage
Copy interval
Copy quantity
Correction amount
132
60
50
10
U101 Setting the other high voltages 27/45/22/45/166/177/37/35
1/35/42
U110 Checking/clearing the drum count -
Developing U130 Initial setting for the developing unit -
U144 Setting toner loading operation Off
U157 Checking/clearing the developing drive time -
U158 Checking the developing count -
Fuser and
cleaning
U161 Setting the fuser control temperature
Primary stabilization fuser temperature
Secondary stabilization fuser temperature
Copying operation temperature 1
Copying operation temperature 2
Number of sheets for fuser control
Number of sheets for fuser control (thick paper)
140
160
170
180
5
20
U162 Stabilizing fuser forcibly -
U163 Resetting the fuser problem data -
U167 Checking the fuser count -
U198 Setting the fuser phase control Off
U199 Checking the fuser temperature -
Operation
panel and
support
equipment
U200 Turning all LEDs on -
U202 Setting the KMAS host monitoring system -
U203 Operating DP separately -
U204 Setting the presence or absence of a key card or key counter Off
U207 Checking the operation panel keys -
U243 Checking the operation of the DP motors and solenoids -
U244 Checking the DP switches -
U245 Checking messages -
Mode setting U250 Setting the maintenance cycle 150000
U251 Checking/clearing the maintenance count 0
U252 Setting the destination Japan
U253 Switching between double and single counts A3
U254 Turning auto start function on/off On
U258 Switching copy operation at toner empty detection Single mode
U260 Changing the copy count timing After ejection
U265 Setting the destination specifications 0
U277 Setting auto application change time 30
U332 Setting the size conversion factor 1.0
U341 Specific paper feed location setting for printing function -
Section
Item
No.
Content of maintenance item
Initial
setting*
*Initial setting for executing maintenance item U020
To Next Page
Loading...
Need help?
General