2HA/2HB
1-3-56
U942
Setting of amount of slack for feeding from DP
Description
Adjusts the amount of slack generated when the optional DP is used.
Purpose
Use this mode if an original non-feed jam, oblique feed or wrinkling of original occurs when the DP is used.
Method
Press the start key.
Setting
1. Select the item using the exposure adjustment keys.
2. Change the setting using the zoom +/- keys.
The greater the value, the larger the amount of slack; the smaller the value, the smaller the amount of
slack.
If an original non-feed jam or oblique feed occurs, increase the setting value. If wrinkling of original
occurs, decrease the value.
3. Press the start key. The value is set.
Supplement
While this maintenance item is being executed, test copying from an original is available.
Completion
Press the stop/clear key. The indication for selecting a maintenance item No. appears.
Maintenance
item No.
Description
Exposure
indicator
Description Setting range Initial setting
Exp. 1 Original conveying motor (OCM)
(in duplex feed)
-10 to 20 0
Exp. 2 Original feed motor (OFM)
(in simplex feed)
-10 to 20 0
To Next Page
Loading...
Need help?
General