Olympia LCD-9210 User Manual

42
Two-line Display
The two-line display enables the simultaneous display of calculation
equation and result.
D The top line displays the calculation equation.
D The bottom line displays the result.
A separator appears after each third digit when the integer part of the
mantissa is more than three digits.
Before Starting to Calculate.....
Operating modes
Before starting to enter a calculation, you must activate the correct mode
as indicated in the following table.
Calculation mode: Keys to be pressed: Mode identification
Basic arithmetic
computation
COMP
Standard deviation SD
Regression REG
D Press the key more than once to display additional setup
screens. The setup screens are described in the sections of this
guide in which they can actually be used in order to change the
calculator settings
D Throughout this guide, the mode necessary to complete specific
calculations appears in the title of each section.
Example: Statistical Calculations: SD; REG
Note!
In order to reset the calculation mode and settings to their default
state, as listed below, press the following keys
(Mode) .
Calculation mode: COMP
Angle unit: Deg
Exponential display format: Norm 1
Fraction display format: a
b
/
c
Decimal point character: Point

Olympia LCD-9210 Specifications

General

Power source	Battery/Solar
Type	Scientific
Wrist rest	No
Form factor	Pocket
Control type	Buttons
Product color	Silver
Housing material	Plastic
Storage media type	-
Digits	12 digits
Display type	LCD
Display size (HxV)	60 x 17.5 mm
Display number of lines	2 lines
Package type	Box
Package depth	115 mm
Package width	225 mm
Package height	37 mm
Package weight	250 g
Harmonized System (HS) code	84701000

Weight and Dimensions

Depth	18 mm
Width	84 mm
Height	162 mm
Weight	110 g