42 EN
Shooting functions – Various shooting functions
3
TIPS
The remote control lamp does not blink after the shutter button on the remote control is
pressed:
J
The transmitted signal may not be effective if the remote control receiver is exposed to
powerful lighting. Move the remote control closer to the camera and press the shutter button
on the remote control again.
J
The transmitted signal may not be effective if the remote control is too far from the camera.
Move the remote control closer to the camera and press the shutter button on the remote
control again.
J
There is signal interference. Change the channel as described in the remote control’s
manual.
To cancel the remote control shooting mode:
J
The remote control shooting mode will not be canceled after shooting. Press the
<
/
Y
/
j
button to set to
o
(single-frame shooting) etc.
To use the shutter button on the camera in the remote control shooting mode:
J
The shutter button on the camera still works even in the remote control shooting mode.
Bulb shooting on the remote control
Set the mode dial to
M
, then set the shutter speed to
[BULB]
.
x
Notes
•
The shutter will not be released if the subject is not in focus.
•
Under bright light conditions, the remote control lamp may be difficult to see, making it hard
to determine whether or not the picture has been taken.
•
Zoom is not available on the remote control.
Press the W button on the remote control to
open the shutter. If 8 minutes elapse after
pressing the W button, the shutter closes
automatically.
Press the T button to close the
shutter.
To Next Page
Loading...
