EN 91
Getting to know your camera better
8
1
Remove the lens from the camera.
2
Set the power switch to ON.
3
MENU
[
Z
]
[CLEANING MODE]
4
Press
d
, then press the
i
button.
•
The camera enters the cleaning mode.
5
Press the shutter button all the way.
•
The mirror goes up and the shutter curtain opens.
6
Clean the image pickup device.
•
Carefully blow off any dust on the surface of the image pickup device by using a
mechanical blower (commercially available).
7
Be careful not to catch the mechanical blower in the shutter curtain
when turning the power off to finish cleaning.
•
If the camera turns off, the shutter curtain closes, causing the mirror to fall.
Pixel mapping – Checking the image processing functions
The pixel mapping feature allows the camera to check and adjust the image pickup device and
image processing functions. After using the monitor or taking continuous shots, wait for at least
one minute before using the pixel mapping function to ensure that it operates correctly.
1
MENU
[
Z
]
[PIXEL MAPPING]
2
Press
d
, then press the
i
button.
•
The
[BUSY]
bar is displayed when pixel mapping is in progress. When pixel mapping is
finished, the menu is restored.
x
Notes
•
Be careful not to let the mechanical blower (commercially available) touch the image
pickup device. If the blower touches the image pickup device, the image pickup device will
be damaged.
•
Never put the mechanical blower behind the lens mount. If the power turns off, the shutter
closes, breaking the shutter curtain.
•
Do not use anything other than the mechanical blower. If high-pressure gas is sprayed
onto the image pickup device, it will freeze on the image pickup device’s surface,
damaging the image pickup device.
x
Notes
•
If you accidentally turn the camera off during pixel mapping, start again from Step 1.
To Next Page
Loading...
