EN 93
Information
9
Formatting the card
Non-Olympus cards or cards formatted on a computer must be formatted with the camera before
they can be used.
All data stored on the card, including protected images, is erased when the card is formatted.
When formatting a used card, confirm there are no images that you still want to keep on the card.
1
MENU
[
W
]
[CARD SETUP]
2
Use
ac
to select [FORMAT]. Press the
i
button.
3
Use
ac
to select [YES].
Press the
i
button.
•
Formatting is performed.
TIPS
When inserting cards into the two card slots:
J
Select the card to be used in
[CF / xD]
of
MENU
.
MENU
[
Z
]
[CF / xD]
[CF] / [xD]
z
Use the single Olympus lithium-ion battery (BLS-1).
Other batteries cannot be used.
z
The camera’s power consumption varies widely with usage and other conditions.
z
As the following consume a lot of power even without shooting, the battery will be drained
quickly.
•
Pressing the shutter button halfway in shooting mode, performing auto focus repeatedly.
•
Displaying images on the LCD monitor for a prolonged period.
•
When connected to a computer or printer.
z
When using a drained battery, the camera may turn off without the low battery warning being
displayed.
z
The battery will not be fully charged at the time of purchase. Charge the battery using the
designated charger (BCS-1) before use.
z
The normal charging time of the provided charger is approximately 210 minutes (estimated).
z
Do not use chargers other than the one designated.
z
The charger should be used within the voltage range of AC 100–240 V (50 / 60 Hz). If used
overseas, a transformer may be necessary. Check with an electrician or travel agent for
details.
z
Do not use commercially available travel adaptors as the charger may malfunction.
Battery and charger
To Next Page
Loading...
