Olympus STM7 - Page 84

X
Y
Z
DATA Z LIMIT
COUNT
FULL
HALF
TRACK
SHOT
COARSE EPI DIA FN
FINE
AF FOCUS LED
X
Y
Z
DATA Z LIMIT
COUNT
FULL
HALF
TRACK
SHOT
COARSE EPI DIA FN
FINE
AF FOCUS LED
78
Closing the maker setting mode
1. Press the X-RESET button
c
to show ”12” in the display X.
2. Press the Y-RESET button
d
or the Z-RESET button
e
to show
"1" in the display Y.
3. Press the DATA button
f
.
The maker setting mode is closed and the microscope can be
used in the normal status.
Without this procedure, the inputted values are not saved
in the microscope. Be sure to execute this procedure.
12
CAUTION
} To load the setting values saved in the microscope, perform
following procedures.
1. Press the X-RESET button
c
to show ”10” in the display X.
2. Press the Y-RESET button
d
or the Z-RESET button
e
to show
"1" in the display Y.
3. Press the DATA button
f
.
The setting values are loaded. The setting value is displayed in
display Y each time you switch display X.
c
c
d
d
e
e
f
f