3 Part Names and Basic Procedures
3 - 2
E5@C Digital Temperature Controllers User’s Manual (H174)
3-1 Basic Application Flow
The following figure shows the basic flow for using the Digital Controller.
Power ON
• Input type
• Control method
• Alarm type
Other parameters
Set the set point.
Set the alarm set values.
Operate with the set values.
*For time-proportional operation.
Set the control hysteresis.
Set the control periods* and PID constants.
ON/OFF Control
PID Control
Set the input type and other basic
settings.
Refer to 3-4 Procedures after
Turning ON the Power Supply.
To Next Page
Loading...
