Omron E5*C Series

4 - 23
4 Basic Operation
E5@C Digital Temperature Controllers User’s Manual (H174)
4-8 Using ON/OFF Control (Not Supported for Position-proportional
Models.)
4
4-8-2 Settings
Setting the Hysteresis
Set the hysteresis to 2.0°C.
Operating Procedure
1 Press the M Key several times in the Adjustment Level to
display hys (Hysteresis (Heating)).
Adjustment Level
2 Press the U or D Key to set the hysteresis to 2.0.
The default is 1.0.
The new set value can be saved by pressing the M Key, or it will go
into effect after 3 seconds has elapsed.
1.0
hys
Hysteresis
(Heating)
2.0
hys