Omron E5AR - MANUAL 2 - Page 220

8.4 Adjustment level (l.adj)
8-17
Setting data
• This sets the output hold interval (the interval while switching the
open output and close output ON and OFF) during position propor-
tional control.
● Related setting data
"Open/Close hysterisis" (Adjustment level) (P.8-17)
• This setting is used to add hysteresis when switching the open
output and close output ON and OFF during position proportional
control.
● Related setting data
Position proportional dead band (Adjustment level) (P.8-17)
Position proportional dead band
db
Position proportional control type
CH
l.adj
Function
Setting
Data range Units Default value
0.1 to 10.0 % 2.0
Reference
Reference
Open/Close hysterisis
oc-h
Position proportional control type
CH
l.adj
Function
Setting
Data range Units Default value
0.1 to 20.0 % 0.8
Reference
Reference