Omron E5AR - MANUAL 2 User Manual

Section 4 Settings Required for Basic Control
4-6
Settings Required
for Basic Control
M
M
Present value (PV) /
SP / MV
Change the input
type with the UD
key
Change the alarm
type with the UD
key
Power on
1, Power on
Alarm 1 type
2: Upper-limit alarm
Alarm 2 type
2→8:
Absolute-value upper-limit alarm
Input initial setting level
Control initial setting level
Control stops
Control stops
Press less than 1 second.
Display 3 will show l.1(control initial setting level).
Check the alarm
type
Alarm setting level
Press twice less than 1 second.
Display 3 will show l.3 (alarm setting level).
2, Input specification
setting
3, Control mode setting
4, Alarm type setting
Input 1 type
2: K(1) - 200.0 to 1300.0°C
Input initial setting level
1. Refer to input type list
(page 8-36)
2. Refer to output type list
(page 8-42)
Hold down for at least 3 seconds.
Display 3 will show l.0 (input initial setting level).
Input type is
displayed
UD
3. Refer to alarm type list
(page 8-54)
Press for at least 1 second to return to RUN level.
25.0
0.0
Input 1 type
2→0: Pt100(1)-200.0 to 850.0°C
Control mode
0: Standard control
Check the control
mode
l.0
l.0
l.1
l.3
RUN level
i1-t
2
l.0
l. 0
i1-t
0
l.1
mode
0
Output 1 type
0: Pulse voltage output
∗
indicates that the key is
pressed several times to
switch to desired setting
data.
l.1
o1-t
0
l.3
alt2
8
l.3
alt1
2
Check "Output 1:
Output type".
0
.0

Omron E5AR - MANUAL 2 Specifications

General

Brand	Omron
Model	E5AR - MANUAL 2
Category	Controller
Language	English