Omron E5AR - MANUAL 2

4.3 Initial setting examples
4-7
Settings Required
for Basic Control
Set alarm value 1with
the UD keys
Set alarm value 2 with
the UD keys
Present value (PV) /
SP / MV
Bank No.
0: Bank No. 0
Adjustment level
Display bank selection
0: Bank No. 0
Bank No. 0 alarm value 1
0.0 →5 . .0 :5.0°C
Bank No. 0 alarm value 2
0.
. 0→200 . .0 :200.0°C
Less than 1 second
Less than 1 second
Less than 1 second
Less than 1 second
Less than 1 second
Run AT with UD keys
Change the control period
with UD keys
Control period (heat)
20.0→0.5:0.5 seconds
AT Execute/Cancel
off→0:AT run
5, Change control period
6, Set alarm value 1
8, Set SP
9, Run AT
Start operation
10, Start operation
Set SP with UD keys
Present value (PV) /
SP / MV
0.0→150.0:150.0°C
4. Auto tuning (A.T)
Refer to page 4-19
RUN level
Bank No.
0: Bank No. 0
Bank setting level
Verify that the display
bank selection is 0
Display PID selection
1:PID set No.1
Present value (PV) /
SP / MV
l.adj
l.bnk
l.adj
After AT ends
AT run in progress
Less than 1 second
25.0
0.0
0.0
l.adj
bank
0
l.adj
cp
0.5
M
l.bnk
d.bnk
0
l.bnk
0.al-1
5.0
l.bnk
0.al-2
200.0
M
M
l.pid
d.pid
1
l.pid
RUN level
25.0
150.0
Adjustment level
l.adj
bank
0
l.adj
at
off
M
RUN level
l.adj
at
0
l.adj
at
off
7, Set alarm value 2
Control begins
Control begins
∗ indicates that the key
is pressed several times to
switch to desired setting data.
0.0
50.0
150.0
150.0
PID setting level