117
Advanced Function Setting Level Section 5-6
• When this setting is set to “ON”, the alarm function is held until the power
is turned OFF once the alarm function has turned ON. Note, however, that
the latch is canceled when the initial setting level, or advanced function
setting level is switched to.
• When alarm output function is set to open in alarm, closed output is held,
and set to closed in alarm, open output is held.
■ Related parameters
“Alarm value 1 to 3” (operation level) (page 81)
“Alarm value upper limit 1 to 3” “Alarm value lower limit 1 to 3” (operation
level) (page 82)
“Alarm 1 to 3 type” (initial setting level) (page 101 and page 102)
“Standby sequence reset” (advanced function setting level) (page 108)
“Alarm 1 to 3 open in alarm” “Alarm 1 to 3 hysteresis” (advanced function set-
ting level” (page 109 to page 110)
• Sets the key pressing time required for moving to the protect level from
the operation level or the adjustment level.
■ Related parameters
“Operation/adjustment protect” “Initial setting/communications protect” “Set-
ting change protect” (protect level) (page 75)
Alarm 1 latch
The alarm 1 function must be ON.
Alarm 2 latch
The alarm 2 function must be ON.
Alarm 3 latch
The alarm 3 function must be ON,
and control must be standard con-
trol.
a1lt
a2lt
a3lt
Setting Range
Default
on: ON / off: OFF off
Function
Setting
See
Move to protect level time
prlt
Setting Range
Unit Default
1 to 30 Second 3
Function
Setting
See
To Next Page
Loading...
