58
SECTION 5
Maintenance
F210
Setup Manual
SECTION 5
Troubleshooting and Maintenance
Regular Inspections
To maintain the Controller in the best condition, perform the following regularly.
• Clean the Lens and LED lights with a lens-cleaning wipe or blow off dust with an aerosol air
sprayer.
• Lightly wipe off dirt with a soft cloth.
• Turn OFF the power and take safety precautions before conducting inspections. Electrical shock can result from
attempting safety inspections with the power turned ON.
• Do not use thinners or benzene to clean the Controller.
Inspection point Details Tools required
Power supply
The voltage measured at the power supply terminals must be
24 VDC +10%/-15%.
Circuit tester
Ambient temperature
The operating ambient temperature inside the cabinet must
be between 0 and 50°C.
Thermometer
Ambient humidity
The operating ambient humidity inside the cabinet must be
between 35% and 85%.
Hygrometer
Installation
Each component must be firmly secured.
The Cameras must be firmly secured.
Mount the Lens on the Camera.
Phillips screwdriver
LED lights
All indicators must light when the power is turned ON.
• Verify that a through-image is displayed.
• When using an Intelligent Lighting, verify that the light level
settings are set to their maximum values.
—
F210setUP.book58ページ２００３年１月２８日 火曜日 午前１１時６分
To Next Page
Loading...
Need help?
General
