Precautions for Correct Use
Do not connect or disconnect the Remote Operation Tool during a measurement or the system
running.
2 The FH/FHV Launcher window appears.
3 Click Remote Operation Tool.
4
Specify the version if it has already been known.
All software versions installed in the PC will be displayed.
Additional Information
When data for Sensor controller project, System +Scene group 0, Scene group, Scene, and
Unit exist, the version of software to be run can be checked by specifying data. For details, refer
to Launching the Remote Operation Tool on page 7 - 6.
5 Click Run.
6 Select or directly input the IP address and Line No. for the Sensor Controller to be connected.
7 Software Setup
7 - 15
FHV Series Smart Camera Setup Manual (Z408-E1)
7-2 Operating the Smart Camera Remotely [Remote Operation Tool]
7
7-2-6 Launching the Remote Operation
To Next Page
Loading...
Need help?
General
