Omron NX1P User Manual

22
Previously
When changing the Unit configuration, you had to change addresses in the ladder program
because the addresses assigned to the I/O channels were changed.
Programming the NX1P
Even when adding Units, you just assign variables to new I/O ports in the I/O Map without
changing the program.
Addresses are changed
Adding
a Unit
Change all related
addresses in the
ladder program
Adding
a Unit
Just assign the device
variables to the I/O
ports of the added
Unit
I/O Map for NX1P

Omron NX1P Specifications

General

Brand	Omron
Model	NX1P
Category	Controller
Language	English