EasyManuals Logo

Omron SYSMAC CPM1 User Manual

Omron SYSMAC CPM1
157 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #118 background image
102
5-8 Handling Precautions
Turn the power OFF before replacing the Unit.
Note Before restarting operation, transfer the contents of the DM and HR areas to the
CPU Unit that was changed and then start operation.
If a Unit is found to be faulty and is replaced, check the Unit again to ensure
there is no error.
When returning a faulty Unit for repair, make a detailed note of the Units mal-
function and take it together with the Unit to your nearest OMRON office or
sales representative.
If a contact is not good, put some industrial alcohol on a clean cotton cloth and
wipe the surface. After doing this, install the Unit.
Standard Tools
Screwdrivers (Philips and flat-blade)
Voltage tester or digital voltage meter
Industrial alcohol and a cotton cloth
Measurement Devices
Synchroscope
Cathode-ray oscilloscope
Thermometer, hydroscope
Note Do not take apart, repair or remodel the PC in any way.
Necessary Tools for
Inspection
Handling Precautions
Section 5-8

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Omron SYSMAC CPM1 and is the answer not in the manual?

Omron SYSMAC CPM1 Specifications

General IconGeneral
Input Voltage100-240V AC
Supply Voltage24 VDC or 100-240 VAC (depending on model)
Number of Inputs6 points
Number of Outputs4 points
Communication PortsRS-232
Operating Temperature0°C to 55°C
Programming LanguageLadder Diagram
Timer/Counter128 timers/counters
Storage Temperature-25°C to 70°C
Humidity10% to 90% (non-condensing)
TypeProgrammable Logic Controller (PLC)

Related product manuals