53
Group DescriptionName
I/O Table Transfer I/O Table Transfers and compares the I/O table data between the computer and PC.
Create I/O Table Registers into the PC the I/O Units mounted on the PC and then assigns the
words to the Units.
Verify I/O Table Compares the I/O table registered in the PC against the I/O Units actually
mounted on the PC.
Clear I/O Table
Deletes the I/O tables (C200H and C200HS PCs only)
Utility
File Memory/
Memory Card
Displays a file memory list; transfers the file memory contents between the PC
and computer or the PC and File Memory Unit; clears the file memory; saves or
retrieves the file memory contents to or from a floppy disk; and edits file memory
contents
Time Chart Monitor Used to execute time chart monitoring and to display, save, or retrieve results.
(C-series PCs only)
Instruction Trace Used to execute instruction traces and used to display, save, or retrieve results.
(C-series PCs only)
Data Trace Used to execute data traces and used to display, save, or retrieve results.
Debug Used to display the execution status of the specified program section.
(C-series PCs only)
Display/Set Clock Used to read and set the internal clock in the PC. (CQM1, C200HS, or CVM1
only)
Transfer Instr Used to transfer expansion instruction set from the PC to the SSS.
(C-series PCs only)
Custom data
Used to transfer customized settings from the SSS to the PC. (CVM1 PCs only)
CPU Bus Unit
Setup
Used to set parameters for SYSMAC NET, SYSMAC LINK, and SYSMAC BUS/2
communications. (CVM1 PCs only)
PC Setup Changes the PC Setup in the PC and in the system work area and used to
transfer the PC Setup between the PC the disk (save/retrieve).
SYSMAC BUS/2
Used to manipulate SYSMAC BUS/2 Remote I/O Master Units. (CVM1 PCs only)
Read Error Log
Used to read the current error and error logs. Also used to force-release the
access right to a PC. (CVM1 PCs only)
Protect UM
Used to protect all or part of the user program by creating passwords. Program
access will not be possible to protected sections without the proper password.
(CVM1 PCs only)
Network Support
Tables
C-series PCs: Used to input data link tables for SYSMAC NET.
CVM1 PCs: Used to transfer data link tables and routing tables between Link
Units, the PC, and the SSS and to compare these tables. Also used
to start and start data links.
Network
Diagnosis
Used to run tests between nodes, to read node status, and to read error logs from
Units for the SYSMAC NET and SYSMAC LINK Systems. Also used for SYSMAC
LINK Systems to run broadcast tests and set network parameters. (CVM1 PCs
only)
Support Software Capabilities Section 4-1
To Next Page
Loading...
Need help?
General
