Omron VARISPEED L7 User Manual

6-68
6
If an error is displayed, set the parameters again. Refer to page 7-16, Digital Operator Copy Function Faults
for corrective actions.
3
Press the Increment and Decrement Key until parameter o3-01 is displayed (Copy Function
Selection).
4 Press the DATA/ENTER Key and select the constants setting display.
5 Change the set value to 2 using the Increment Key.
6 Set the changed data using the DATA/ENTER Key. The COPY function starts.
7 If the COPY function ends normally, “End” is displayed on the Digital Operator.
8 The display returns to o3-01 when a key is pressed.
Step
No.
Explanation Digital Operator Display
COPY Function
-ADV-
o3 - 01 = 0
Copy Funtion Sel
Copy Function Sel
-ADV-
o3-01= 0
COPY SELECT
*0*
Copy Function Sel
-ADV-
o3-01= 2
OP INV WRITE
*0*
COPY
-ADV-
OP INV
COPYING
COPY
-ADV-
COPY COMPLETE
Copy Function Sel
-ADV-
o3
-
01 =0
COPY SELECT
*0*

Omron VARISPEED L7 Specifications

General

Brand	Omron
Model	VARISPEED L7
Category	Inverter
Language	English