Omron VARISPEED L7 User Manual

3-4
3
Note: Except in diagrams, Keys are referred to the key names listed in the above table.
There are indicators on the upper left of the RUN and STOP keys on the Digital Operator. These indicators
light or flash to indicate the inverter operation status.
The RUN key indicator flashes and the STOP key indicator lights during initial excitation or DC braking. The
relationship between the indicators on the RUN and STOP keys and the Inverter status is shown in Fig 3.3.
Fig 3.3 RUN and STOP Indicators
FWD/REV Key
Selects the rotation direction of the motor when the Inverter is oper-
ated by the Digital Operator.
Shift/RESET Key
Sets the active digit when programming parameters.
Also acts as the Reset key when a fault has occurred.
Increment Key
Selects menu items, sets parameter numbers, and increments set val-
ues.
Used to move to the next item or data.
Decrement Key
Selects menu items, sets parameter numbers, and decrements set val-
ues.
Used to move to the previous item or data.
DATA/ENTER Key Enters menus and parameters, and set validates parameter changes.
RUN Key
Starts the Inverter operation when the Inverter is controlled by the
Digital Operator.
STOP Key
Stops Inverter operation.
This key can be enabled or disabled using parameter o2-02 when
operating from a source different than the operator.
Key Name Function
RUN
Inverter Output frequency
STOP
Frequency reference
STOP
RUN
STOP
Light up
Blink
Off

Omron VARISPEED L7 Specifications

General

Brand	Omron
Model	VARISPEED L7
Category	Inverter
Language	English