97
8.3.3 Poor Engraving Results
Issue
When this issue occurs, you may find
the engraving performance is not as
expected: the pattern appears blurry, and
the engraving outcome is excessively
darkening or too shallow to be identified.
Solution
Check the Processing
Parameters
For materials suggested in this manual, you can choose the
recommended parameter values for cutting.
For those not suggested, you can get the ideal parameter values
after several tests.
Check the Material
Distance/Thickness
Value
Check if the material thickness/distance is out of the standard range of
the engraver.
Set a lower airflow rate
Adjust the airflow of the air duct
by pressing Slow on the remote
control.
Check the Focal Lens
When the focal lens is not installed properly, the laser spot will become
larger, decreasing engraving performance.
See
§7.2.2
Cleaning the Camera, Mirrors, and Focus Lens (Page 81).
Check the Material
Some materials can be harder to engrave by laser. To get better
results, set a higher processing power or use less dense materials.
For recommended settings on materials, see
§1.6
Material Safety
Instructions (Page 6).
Calibrate the Laser Path
When the laser path is misaligned, the laser performance may vary
significantly in different processing areas.
Contact our service to guide you on calibrating the laser path if the
solutions above don’t work.
8 Troubleshooting
To Next Page
Loading...
