8
This machine CAN NOT be used with the following materials or with any materials that include
them:
1.7 Disposal Safety Instructions
Electrical products should not be disposed of with household products. In the
EU and UK, according to the European Directive 2012/19/EU for the disposal of
electrical and electronic equipment and its implementation in national laws, used
electrical products must be collected separately and disposed of at the collection
points provided for this purpose. Locations in Australia, Canada, and the United
States may have similar regulations. This engraver’s R-410A refrigerant also
requires special handling for reuse or legal disposal. Contact your local authorities
or dealer for advice.
•
Artificial Leather containing Hexavalent Chromium (Cr [VI]), due to its toxic fumes
•
Astatine, due to its toxic fumes
•
Beryllium Oxide, due to its toxic fumes
•
Bromine, due to its toxic fumes
•
Chlorine, including Polyvinyl Butyral (PVB) and Polyvinyl Chloride (PVC, Vinyl, Sintra, etc.),
due to its toxic fumes
•
Fluorine, including Polytetrafluoroethylenes (Teflon, PTFE, etc.), due to its toxic fumes
•
Iodine, due to its toxic fumes
•
Metals, due to their conductivity and reflectivityPhenolic Resins, including various forms of
Epoxy, due to their toxic fumes
•
Polycarbonate (PC, Lexan, etc.), due to its toxic fumes
For all other materials, if you are unsure about its safety or laserability with this engraver, seek
out its material safety data sheet (MSDS). Pay special attention to information about safety,
toxicity, corrosiveness, reflectivity, and reaction(s) to high heat. Alternatively, contact our support
department for further guidance.
To Next Page
Loading...
