58
6.2.3 Loading Your Design
You can load your design in one of the following 3 ways. Select the option that best fits your needs.
Via Your Control Computer
1. Create the design that you’d like to engrave and save.
You can do this directly in your engraving software or use any other graphics program.
2. Confirm that your control computer has a connection to the Polar, either directly through the
provided USB cable, Wi-Fi connection or via the internet. For instructions on connection, see
§
4.6 Setting up the Control System (Page 31).
3. Load your saved design into your engraving software.
4. Turn on your engraver using its rear power
switch and the laser key.
5. Confirm that the cooling system, air assist,
exhaust fan, and internal lights have been
activated.
To Next Page
Loading...
