98
8.3.4 Engraving Image Shifts During Processing
Issue
The engraved image is deviated or won’t close up
because of the losing steps in processing.
Solution
Lower the Speed of
the Engraving Process
If the processing speed is too fast, it may cause step loss.
Please try again by lowering the speed.
Adjust the Tightness of
the Timing Belts
Contact our customer service for instructions on adjusting the tightness
of the X-axis and Y-axis timing belts so that the laser module can move
smoothly.
Checking the Stability
of the Material
If the material is too light, the gas coming out of the air nozzle may
nudge the material, causing a deviated image.
Use the material clamp or tape to fix the material before processing.
Check the Material
Distance/Thickness
Value
If the air nozzle hits the material because of the failure of focusing,
which leads to the deviation of the image, check if the material
thickness or distance is the same as the actual value.
To Next Page
Loading...
