61
6 Operation
6.2.5 Autofocusing Your Laser
Autofocusing your laser every time you move the material or use a new material.
1. Move the laser head over the sample material.
6.2.6 Engraving
You can use either the software or the touch screen to operate engraving.
2. Press the autofocusing key on the touch screen. The
laser head should automatically move toward the sample
material, then move backward, and finally stop when the
correct focal height has been reached.
1. Outline the projected area for engraving or cutting on your
material by clicking
on the touch screen or Go scale on
the software. The laser traces the boundary, allowing you
to ascertain that the laser path is properly aligned with your
material setup.
To Next Page
Loading...
