45
5.1.2 Tray Shutoff
After ensuring that the cover shutoff works, you should also test that the tray shutoff activates.
1. Perform the same procedure as before but, instead of opening the cover, open the debris tray.
The laser should stop completely. If it continues to engrave the design while the debris tray is
open, the automatic shutoff is not working and must be repaired before the engraver can be used.
5 Initial Testing
8. Check the status of the engraver.
The laser should pause automatically and the Start button should become red.
If the laser continues to engrave the design while the cover is raised, the automatic shutoffs are
not working and must be repaired before the engraver can be used. Turn off the machine and
contact our technical support team.
9. Close the cover and press the Start button.
The engraver should restart cutting or engraving.
10. Turn off the engraver after the test is done.
2. Turn off the machine. Contact our technical support team if the tray shutoff is not working.
To Next Page
Loading...
