17
3.2 Front View
3 Components
A Cover
This acrylic window allows you to monitor the engraving process,
absorbing most reflected laser beams. However, always use
protective eyewear when observing the active laser and never stare
at it for extended periods.
B Cover Interlocks These switches automatically pause work if the cover is opened.
C Camera This fisheye camera helps you position your designs precisely.
D LED Light Strips These integrated lights help keep your workbed easy to see.
E Digital Touch screen This is the main control panel for the laser.
F
Start Button and
Laser Status
This button can be used to pause and restart engraving or to repeat
the previously loaded design with its former settings. To start a
new design or engrave with adjusted settings, use your software’s
commands. The ring around the button changes color to indicate your
engraver’s current status:
Status Color
Blue
Meaning
Active Laser
Green Ready to Work
Red Error or Malfunction
G Debris Tray
This tray is easily removable to clean debris after use and to install or
remove the honeycomb workbed. It can also be left open to function
as the front pass-through.
H Laser Key
This lock turns the laser power supply on and off, helping ensure that
only approved operators can use your laser.
I Legs These padded legs help avoid any damage to your table or counter.
A
D
G
F
E
H
I
C
B
To Next Page
Loading...
