51
6.1 Operation Overview
This section will address only some of the options and features provided by the operation software.
Before beginning to use the machine, make sure that you have read this entire manual (particularly
§
Safety Information on Page 1), the separate software manual, and any warnings provided on the
machine itself.
Here are the main operation steps:
6 Operation
Operate this laser engraver only in accordance with all the instructions provided
in this manual.
Failure to follow these instructions can result in property damage and personal
injury.
Wear safety glasses during the entire test process!
Prepare your material
Start
Turning on your engraver
Adjust parameters
Loading your design and
adjusting the software’s
parameters
Focusing Your Laser
Engrave or cut
Power off
End
No
Is the result ok?
Yes
To Next Page
Loading...
