57
4. Confirm that the rotary switch is flipped down to its standard position and then close the cover.
6 Operation
For round pieces, you will need to use a rotary axis. For instructions, see
§6.3
Instructions for
Rotary Operation on Page 65.
6.2.2 Turning on Your Engraver
X-Axis Rail
1. Turn on your duct fan and any fume extractor
or other ventilation equipment.
2. Turn the beam attenuator completely
clockwise to enable your software to use the
engraver’s full power range.
3. Insert the interlock connector—if you don’t
normally leave it in place.
For your safety and that of passersby, this engraver requires two keys to
provide power to the laser tube, the front key (laser power key) and the rear
key (remote interlock connector).
Operators should ALWAYS remove at least one of these between uses to
prevent unauthorized operation of the machine. Only leave them in place if the
work area itself is completely secure and inaccessible to any children.
To Next Page
Loading...
