56
b. Remove the debris tray and workbed.
c. Slide the X-axis rail forward to expose
the tray interlock switch.
d. Move the tray interlock switch into a
closed position and hold it there by
sliding the nearby metal bracket to the
right.
Never leave the switch in this position
after completing your work. Reenable the
switch before leaving the work area.
X-Axis Rail
Bracket
Tray Interlock Switch
e. Replace the workbed as needed.
f. Put your material on the workbed or
the tray through the tray and rear pass-
through door.
DO NOT insert anything through the pass-through doors other than your
material. As you work, confirm the ventilation system is removing all dust
and fumes. If it cannot, cease use of the pass-through for that material
unless sufficient PPE is worn by everyone nearby.
To Next Page
Loading...
