55
Thickness Instructions
＞
51 mm
4. Slide the X-axis rail forward to expose the tray interlock switch.
5. Move the tray interlock switch into a closed position and hold it there
by sliding the nearby metal bracket to the right.
Never leave the switch in this position after completing your work.
Reenable the switch before leaving the work area.
6. Use 4 identical pads at each corner to elevate the engraver.
7. Use another identical pad for elevating the plank that is used to
protect the table.
6 Operation
X-Axis Rail
Bracket
Tray Interlock Switch
Make sure the combined height of the pad and the
plank equals however much the material exceeds 51
mm in thickness.
For Pieces Longer Than 20 Inches (510 mm) and No Thicker Than 51 mm
You should open the tray and rear pass-through door to provide more space.
Rear Pass-Through
a. Open the rear pass-through door.
Material
51 mm
Pad
To Next Page
Loading...
