35
4 Installation
4.7 Setting up Wi-Fi
1. Check your local wi-fi networks to see if
“Polar350” already exists. If so, log into it
using the default password 123456abc.
2. Reconfigure your own device’s TCP/IP
address. The default address of the Polar+’s
wireless network is 192.168.1.100. You will
need to set your computer’s network to use
a similar but not identical address.
a. Use 192.168.1 for the first three sections
and a unique value for the last section.
Typically, any value from 2–252 except
47 and 100 should be fine but avoid
any values already used by your other
networked devices.
b. Use the subnet mask 255.255.255.0.
Subnet mask:
IP adress:
255 . 255 . 255 . 0
192 . 168 . 1 .
3. Enable wireless control in RDWorks by going
to Device on the lower right side of the main
interface.
If it is not visible, remove the other menus
above it until it becomes visible.
For LightBurn and other software setup,
contact Customer Service, visit the OMTech
website, or see our YouTube channel.
To Next Page
Loading...
