63
6 Operation
5. Once the laser has stopped, examine the quality of your first
run. You can compare the engraving result of the material
with that on the reference board.
6. Adjust the parameters in your software as necessary. You can
adjust the values of power and speed based on the reference
board.
The mainboard can be reset by using the reset key
if you encounter any problem.
If an error occurs during the reset process
preventing successful reset or if you wish to stop
the reset, you can click on the
icon in the
center of the screen to halt the reset process.
If your engraver stops during repetitive engraving
and cutting, the cooling system may have reached
122
℉
(50
℃
) and automatically paused work.
Resume work by pressing the engraver’s Start
button only after the system has had time to
adequately cool. If possible, use lower power
settings while reducing speed or increasing the
number of times your design is processed.
7. Begin your real work in a different location or on a different piece of material. You can also
click
on the touch screen or press the Start button to repeat your last loaded design without
applying any changes.
To Next Page
Loading...
