68
9. Enable the rotary axis function on your RDWorks V8 software
by locating the Enable rotating function under User tab, and
choose Yes.
10. Measure and fill in the Diameter parameter of the object on your
RDworks V8 software. To measure Diameter, you can use either
a ruler or a caliper, but a caliper provides an accurate reading.
For a curved-surface object, take the average value of the
diameter of the actual engraving range of the measured object
(the average value of the left, middle and right of the engraving
range position).
Do not forget to update the parameter of
the object every time you change the object.
To Next Page
Loading...
