78
Interior of the Main Bay
Do not use caustic chemicals or harsh abrasives. Be careful not to allow any
electronic component to become wet and let all surfaces dry completely before
further use.
Do not leave standing water in the tray.
•
Clean the interior of the main bay thoroughly, removing any debris particles or deposits. Paper
towels and window cleaner are recommended.
•
When it is necessary to clean the right or left sides of the main bay thoroughly, the plastic
panels that cover them can be removed for easier access.
1. Turn off and unplug the engraver.
2. Open the cover and disconnect all the electronic items on each side.
•
Removing the right panel requires unplugging its LED light as well as the induction
switch and key line.
To Next Page
Loading...
