You can set the parameters of the treatment:
• treatment time by the „Set time” option
• treatment power by the „Set power” option
• turn on or off the modulation of the power by the „Modulation
on/Modulation off” button (the text of the button depends on the
current setting)
These parameters are changeable during the treatment too.
By clicking on the „Start” button you can start the treatment, but you have to
reconfirm it on the automatically appearing „Start treatment” page, where
you can check the set treatment parameters.
After the reconfirmation you will get back to the „Treatment management
view” screen (see previous page), where you can check the parameters of
the treatment:
• Set power
• Treatment power
• Forwarded power
• Reflected power
• Elapsed time
To Next Page
Loading...