ONE Technologies
- 101 -
access this disk with other operation systems or older disk utilities, do
not enable large drive support.
Do you want to enable large disk support?
3. Here you decide if you want to use FAT16 (max. 2GB per
partition) or FAT32 (up to 2 terabyte per partition) to format the
drive. For FAT16 enter “n” and press ENTER, for FAT32 enter “y”
and press ENTER. The main menu appears with the following
options:
1. Create DOS partition or logical DOS Drive
2. Set active partition
3. Delete partition or logical DOS Drive
4. Display partition information
5. Change current fixed disk drive
4. When FDISK starts, the system hard drive (normally C:) is the
actual disk. You have to change the actual drive to the new drive.
Select option 5 and change the disk drive (all drives are shown in an
overview). The new one is the disk were the total capacity is shown
as free space. Choose it and return to the main menu.
5. Back in the FDISK-Main-Menu, select option 1 (Create DOS
partition….)
6. Again select option 1 (Create Primary DOS Partition) in the new
submenu.
After you press ENTER, you receive the following message:
Do you wish to use the maximum available size for primary DOS partition?
If you accept by pressing “Y” all available space will be used. If you
want to create more than one partition, you have to enter “N” for
no.You now have the possibility to enter the desired capacity.
To Next Page
Loading...