ONE Technologies
- 27 -
In the next step you have to define where to store the backup data.
Use the pull down menu to select the target (disk or partition to save
the data to). Here you choose the ONE AluDISC Backup e.g. For
our example you can leave the setting as preselected. Make sure
the option “ONE Technologies Backup” is marked. If not, the backup
cannot be executed by the front buttons of the AluDISC! For future
use, we recommend to leave the option “Verify data after backup”
enabled to make sure that the backup has been successfully
created.
To Next Page
Loading...