Onkyo A-9070

20
En
With u (Remote Interactive), you can use the following
special functions:
■ Auto Power On
When you start playback on a component connected via
u while the integrated amplifier is on Standby, the
integrated amplifier will automatically turn on and
select that component as the input source.
■ Direct Change
When playback is started on a component connected via
u, the integrated amplifier automatically selects that
component as the input source.
■ System Off
When you turn off the integrated amplifier, the
components turn off automatically.
■ Remote Control
You can use the integrated amplifier’s remote controller
to control your other u-capable Onkyo Network
Tuner or RI Dock, pointing the remote controller at the
integrated amplifier’s remote control sensor instead of
the component.
Tip
• For details on operating the connected components, see
“Controlling Other Onkyo Components” (➔ page 32).
Note
•Use only u cables for u connections. u cables are supplied
with your Onkyo CD Player, Network Tuner or RI Dock.
•If two u jacks are present, you can use either one indifferently
as they work the same way.
• Connect only an Onkyo CD Player, Network Tuner or RI Dock
to the u jacks. Connecting other manufacturer’s components
may cause a malfunction.
• Only Onkyo CD Players (e.g. C-7070), Network Tuners (e.g.
T-4070), and RI Docks (e.g. ND-S1000) are supported by the
integrated amplifier’s u. With other components such as MD
recorders, the u won’t work properly.
• Some components may not support all u functions. Refer to
the manuals supplied with your Onkyo CD Players, Network
Tuner or RI Docks.
• The CD Players only support the Auto Power On and Direct
Change functions.
Connecting Onkyo u Components
Y
B
D
N
A
T
S
/
N
O
Y
B
D
N
A
T
S
d
o
P
i
C
P
/
C
N
Y
S
C
N
Y
S
N
U
Integrated Amplifier A-9070
RI Dock
Network Tuner or CD Player
1
Change the names of inputs in accordance with
each component connected (➔ page 35).
Connected component Names of inputs
CD Player CD
Network Tuner TUNER
RI Dock DOCK
2
Make sure that each Onkyo CD Player, Network
Tuner or RI Dock is connected (➔ pages 17 to 19).
3
Make the u connections (see the illustration).