EasyManuals Logo

Onkyo A-9070 User Manual

Onkyo A-9070
44 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #7 background imageLoading...
Page #7 background image
7
En
Before Using the Integrated Amplifier
Note
If the remote controller doesn’t work reliably, try replacing the
batteries.
Don’t mix new and old batteries or different types of batteries.
If you intend not to use the remote controller for a long time,
remove the batteries to prevent damage from leakage or
corrosion.
Remove expired batteries as soon as possible to prevent damage
from leakage or corrosion.
To use the remote controller, point it at the integrated
amplifier’s remote control sensor, as shown below.
Note
The remote controller may not work reliably if the integrated
amplifier is subjected to bright light, such as direct sunlight or
inverter-type fluorescent lights. Keep this in mind when
installing.
If another remote controller of the same type is used in the same
room, or the integrated amplifier is installed close to equipment
that uses infrared rays, the remote controller may not work
reliably.
Don’t put anything, such as a book, on the remote controller,
because the buttons may be pressed inadvertently, thereby
draining the batteries.
The remote controller may not work reliably if the integrated
amplifier is installed in a rack behind colored glass doors. Keep
this in mind when installing.
The remote controller will not work if there’s an obstacle
between it and the integrated amplifier’s remote control sensor.
Installing the Batteries
1
To open the battery compartment, press the small
hollow and slide the cover.
2
Insert the two supplied batteries (R03) in
accordance with the polarity diagram inside the
battery compartment.
3
Replace the cover and slide it shut.
Using the Remote Controller
Remote control sensor
Integrated amplifier
Approx. 16 ft. (5 m)

Table of Contents

Other manuals for Onkyo A-9070

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Onkyo A-9070 and is the answer not in the manual?

Onkyo A-9070 Specifications

General IconGeneral
Damping factor130
Amplifier class-
Input sensitivity150 mV
Audio output channels2.0 channels
Peak power per channel140 W
Signal-to-Noise Ratio (SNR)107 dB
Total Harmonic Distortion (THD)0.006 %
Dynamic power per channel (3 Ohm)230 W
Dynamic power per channel (4 Ohm)180 W
Dynamic power per channel (8 Ohm)100 W
AC (power) inYes
Headphone connectivity6.3 mm
Speakers connectivity typeRCA
PurposeHome
Product colorBlack
Volume controlRotary
Cables includedAC
Connectivity technologyWired
AC input voltage230 V
AC input frequency50 Hz
Power consumption (typical)290 W
Weight and Dimensions IconWeight and Dimensions
Depth431 mm
Width435 mm
Height174.5 mm
Weight18100 g

Related product manuals