Onkyo A-9070

21
En
Use the MM/MC selector on the back of the integrated amplifier to select either MM or MC, in accordance with the
cartridge format of the turntable.
Remove the short pins plugged into the jacks before connecting a turntable to the PHONO inputs.
Note
• Always turn off the integrated amplifier before switching between
MM and MC.
Tip
• If your turntable has a built-in phono preamp, you can connect the turntable to other analog inputs such as LINE IN 1.
• If your turntable has a ground wire, connect it to the GND screw. With some turntables, connecting the ground wire may produce an
audible hum. If this happens, disconnect it.
Tip
• Connect your cassette tape deck to either of the following jacks: LINE IN 1/2/3.
Connecting a Turntable
Connecting a Cassette Tape Deck
L
R
AUDIO
OUTPUT
Turntable without a built-in
phono preamp
Integrated Amplifier A-9070
MM/MC selector
AUDIO
OUT
LR
Integrated Amplifier A-9070
Cassette tape deck