Onkyo A-9070 User Manual

25
En
Combined with a preamplifier of your choice, the integrated amplifier can be used as a power amplifier (Main mode).
When it is selected, the MAIN IN LED lights. See “Connecting Your Speakers” for connection information
(➔ page 13). This is an example of connection using the preamplifier P-3000R.
Using the Integrated Amplifier as a Power Amplifier
Important:
• Always turn the integrated amplifier off before connecting the MAIN IN jacks.
• Before setting the integrated amplifier to Main mode, make sure that no component such as a CD player is connected to the MAIN
IN jacks, as a direct connection may cause a massive blast sound and damage the integrated amplifier or your speakers.
• This mode can be used with the following limitations:
– The volume level can’t be adjusted.
–Only SPEAKERS and SETUP can be used.
–Only the MAIN IN and SPEAKERS terminals can be used.
– The Auto Standby function is not available (➔ page 38).
• To use this mode, you need to change the “ROUTE” setting (➔ page 39).
Preamplifier P-3000R
Integrated Amplifier A-9070

Onkyo A-9070 Specifications

General

Damping factor	130
Amplifier class	-
Input sensitivity	150 mV
Audio output channels	2.0 channels
Peak power per channel	140 W
Signal-to-Noise Ratio (SNR)	107 dB
Total Harmonic Distortion (THD)	0.006 %
Dynamic power per channel (3 Ohm)	230 W
Dynamic power per channel (4 Ohm)	180 W
Dynamic power per channel (8 Ohm)	100 W
AC (power) in	Yes
Headphone connectivity	6.3 mm
Speakers connectivity type	RCA
Purpose	Home
Product color	Black
Volume control	Rotary
Cables included	AC
Connectivity technology	Wired
AC input voltage	230 V
AC input frequency	50 Hz
Power consumption (typical)	290 W

Weight and Dimensions

Depth	431 mm
Width	435 mm
Height	174.5 mm
Weight	18100 g