Onkyo R-N855

En- 24
Connecting with Onkyo RI Components
By connecting an Onkyo component with RI jack to the
unit by using an RI cable and an analog audio cable, you
can link the unit’s power and input selection and enable
operation with this unit’s remote controller. For details,
refer to the instruction manual of the component with the
RI jack.
a RI cable, b Analog audio cable
0 If there are two RI connectors, the funciton of the two
connectors is the same. Both connectors can be used.
0 Connection to RI connectors only does not work as the
system. Connect also an analog audio cable correctly.
0 Some components may not support all RI functions.
a
b
SN29402579_R-N855_En_1608xx.book 24 ページ ２０１６年９月１３日 火曜日 午前９時１２分