Opengear ACM7000 User Manual

Chapter 4: Firewall, Failover & OOB Access
96
The Operational Status changes as the cellular modem finds a channel and connects to the network
The Failover & Out-of-Band screen displays information relating to a configured Failover/OOB
interface and the status of that connection. The IP Address of the Failover / OOB interface is be
presented in the Failover & Out-of-Band screen when the Failover/OOB interface is triggered
4.7.3 Cellular routing
Once you have configured carrier connection, the cellular modem can be configured to route traffic
through the console server. This requires setting up forwarding and masquerading as detailed in Chapter
4.8.
4.7.4 Cellular CSD dial-in setup
Once you have configured carrier connection, the cellular modem can be configured to receive Circuit
Switched Data (CSD) calls, a legacy form of data transmission developed for the TDMA based mobile
phone systems like GSM.
NOTE CSD is provided selectively by carriers and it is important you receive a Data Terminating number
as part of the mobile service your carrier provides. This is the number which external modems call
to access the console server
1. Select the Cellular Modem panel on the System > Dial menu
2. Check Enable Dial-In and configure the Dial-In Settings
4.8 Firewall & Forwarding
Opengear console servers have basic routing, NAT (Network Address Translation), packet filtering and
port forwarding support on all network interfaces.

Opengear ACM7000 Specifications

General

RS-232 ports	8
SIM card slot	Yes
USB 2.0 ports quantity	4
Number of simultaneous SIM cards	2
Certification	EN 55022:2010, CISPR 22:2008, FCC Part 15 B:2015, ICES-003 5 (2014), AS/NZS CISPR 22:2009+A1:2010, EN 61000-3-2:2006/A2:2009, EN 61000-3-3:2008 EN 55024:2010, CISPR 24:2010, EN 61000-4-2:2009, EN 61000-4-3:2006+A2:2010, EN 61000-4-4:2004+A1:2010, EN 61000-4-5:2006, EN 61000-4-6:2009, EN 61000-4-8:2010, EN 61000-4-11:2004 CE, UL 1950, TUV, C-Tick, RoHS
Mounting type	Rack mounting
Product color	Black, Red
Antenna connector type	SMA
Flash memory	32 MB
Internal memory	256 MB
Processor frequency	800 MHz
Control display unit	No
Internal memory type	DDR3
Input voltage	110 - 240 V
DC input voltage	12 V
Storage temperature (T-T)	-40 - 75 °C
Operating temperature (T-T)	-25 - 60 °C
Operating relative humidity (H-H)	5 - 90 %
Security algorithms	IPSec, SSH-2, SSL/TLS

Weight and Dimensions

Depth	120 mm
Width	130 mm
Height	35 mm
Weight	6000 g