Opengear CM7100 User Manual

Chapter 6: Alerts, Auto-Response & Logging
140
3. Check Trigger on Authentication Error to trigger when a user fails to authenticate to the Web
UI. This check is not resolvable so Resolve actions are not run.
6.2.14 Network Interface Event
You may wish to configure a change in the network status as the trigger event (e.g. to send an alert or
restart a VPN tunnel connection):
1. Click on Network Interface as the Check Condition
2. Select the Interface (Ethernet /Failover OOB Interface or Modem or VPN) to monitor
3. Check what type of network interface Event to trigger on (interface Down, Starting, Up or
Stopping). This check is not resolvable so Resolve actions are not run.
6.2.15 Routed Data Usage Check
This check monitors the specified input interface for data usage that is being routed through the
Opengear and out another interface such as the Internal Cellular Modem.
It is useful in IP Passthrough mode to detect when the downstream router has failed over and is routing
via the Opengear’s modem as a backup connection.
This check may be configured with these parameters:

Opengear CM7100 Specifications

General

Brand	Opengear
Model	CM7100
Category	Server
Language	English